Body Paintless Repair Removal Tools Door Ding Dent Silde Hammer Glue Puller Repair Starter
- List PriceUS$41.99piece
- Sale PriceUS$41.99piece
- ShippingFree Shipping
Car Body Paintless Dent Repair Removal Glue Gun Tool Kit Puller Lifter T-Bar Kit
-All tabs have a design on the face and easily remove glue after use.
-Environmental protection and it does not damage the original paint.
-Can removal the dent by yourself, Suitable for any person to operate, it has the advantages of simple operation, repair the dent for you directly.
-Suitable for the sheet metal processing of automobile, refrigerator, motorcycle body and washing machine etc.
-One screw on the top of the dent lifter is used to adjust the middle height of the dent lifter.
-On the bottom of the dent lifter is silicone, not ordinary rubber,which is very soft and not harmful for oil paint and can be teared down.
How to use this paintless dent repair kits?
1. Clean the dent with a clean wet cloth.
2. Mount the glue stick into the glue gun, pull the trigger to let the glue stick enter into the glue gun, connect the power source and preheat for 5 minutes.
3. Use a proper drawing gasket. Large dent requires a large drawing gasket. (Note: The larger the drawing gasket is, the larger the drawing force is).
4. Pull the trigger and apply the drawing gasket with extruded glue.
5. Fast place the drawing gasket with hot melt glue at the center of dent, press lightly until the glue cures and adheres (Let the glue cool for about 8 minutes.
The cooling time should be less than 10 minutes and should be shorter slightly in winter).
6. Align the T-shaped repairer and press the drawing gasket with hot melt glue, pull the sliding rod backwards to pull up the dent.
7. Check with a Line board. If dent still exists, knock it slightly with a flattening hammer or pen.
8. Clean the repaired place with a clean wet cloth.
1 Diameter of the glue strips should be 7mm.If the the applied stick doesn't match,the glue gun may be damaged.
2 The nozzle and the glue liquid are hot when the gun is working, please don't touch it.
3 If the glue gun doesn't work for 15min, please cut off the power source to avoid the melting glue recirculating or damage.
4 It may has the light smoke the first use, it is normal and it will die off 10min later.
5 Please let the bracket stand to cool down the gun for several minutes after use, and don't change the other power cord with it.
6 If the strip is left after use, please don't pull it off,just let it in the gun for the next use.
7 It is normal for some glue flowing out after the few seconds you finish working because of the inertia pressure.
1 x Glue gun
1 x Dent lifter
5 x Glue Sticks
5 x Blue Glue Tabs
1 x T-bar